Freerider FR1 - Manual (Page 16)

15
FREEWHEELING YOUR SCOOTER
If for reasons of convenience, or you require to push your Scooter for a short
distance, the drive system can be put into ‘freewheel mode’. This will allow your
Scooter to roll freely.
1.Freewheel Procedure:
The freewheel device is a red lever located at the rear right hand side of your
scooter.
To freewheel your scooter first switch off the power switch located on the scooter’s
control console.
Pull up the disengage lever until a distinct click is felt. You can now push your scooter
with ease.
Please note, in this mode with the power switch in the off position, the braking safety
system is automatically activated when the Scooter is pushed quicker than walking
speed, this is an automatic ‘run away’ safety checking system, it also reduces the risk
of casual theft. Safety instructions and warnings
ELECTROMAGNETIC AND RADIO FREQUENCY INTERFENCE (EMI/RFI)
Electromagnetic and radio Frequency Interference can come from mobile phone,
radio transmitters etc. In some cases, these waves can cause damage to control
system. Your scooter has an immunity to EMI, the higher the immunity level, the
greater the protection against EMI.
Your scooter has been tested and passed at an immunity level of 20 V/M.
Warning: Additional of accessories or components to your scooter can increase the
susceptibility to EMI. Do cot modify scooter in any way not authorized.
1.Safety Check:
We recommend that you perform a safety check before each use to make certain
your Scooter operates smoothly and safely.
SAFETY INSTRUCTIONS & WARNING