Fire By Design AUTOMATED TIKI TORCH - Manual (Page 7)

7
B – 1”
Step 6
Install ½” gas line to your gas riser (or manual gas shutoff
valve) such that the end of the ½” gas line is 1” SHORTER
than measurement “B” from the previous page. In
addition, bring the wires previously installed up along the
gas line and tape it to the gas line in anticipation of
installing the longer tiki pole.
Step 7
Measure from the bottom of the long tiki pole up to
measurement “A” and mark the pole. Then drill a 1”
diameter hole in the side of the pole for the Manual Gas
Shutoff Valve.
A
Step 8
Next install the Manual Gas Shutoff Valve as shown in
photo at left.