Fire By Design AUTOMATED TIKI TORCH User Manual

Page 6

Text mode
Original mode

1” above ring

Arrow

Note: If you are NOT locating the Manual Gas Shutoff ON the Tiki Pole skip to Step 5 below

Step 3

If you are installing the Manual Gas Shutoff on the Tiki
Pole (Option 2 from page 4) first remove the handle
from the Ball Valve and then install the ball valve on the
½” gas riser as shown in the photo at right. The use of
pipe dope or Gas Teflon tape is highly recommended to
prevent a possible gas leak.

Step 4

Once the Manual Gas Shutoff is installed
measure from the center of the Gas Shutoff to
the top of the Black Base Pole. This dimension
we shall refer to as measurement “A”.

Step 5

Temporarily install the longer tiki pole and measure from
the seam between the Base Pole and the top of the long tiki
pole. This dimension we will refer to as measurement “B”.