Eowave Eobody1 - Manual (Page 19)

Same as Prm 1, depending on what type of MIDI information are sent.
19
manual ©eowave/Ircam 2003
user’s manual • IV.6. - Knobs and Switches window
Prm2
multipurpose
parameter #2
0 - 127
This field enables the user to configure the note on activation level for
trigger messages or for the MSB controller number.
Type of message Res. Val1 Prm1 Prm2
CC - Control Change 7 bits CC value
CC - Control Change 10 bits CC MSB CC LSB
Note - Note on trigger 7 bits note number higher threshold lower threshold
PC - Program Change 7 bits PG value higher threshold lower threshold
PB - Pitch Bend 7 bits
PB - Pitch Bend 10 bits
ATp - polyphonic aftertouch 7 bits note number
ATm - monophonic aftertouch 7 bits
Prm1
multipurpose
parameter #1
0 - 127
Configuration map for analogue inputs
IV.6. Knobs & Switches Window
Enables to set the 4 switches and the 3 potentiometers from the front panel of eo•body.
Note that switches and potentiometers do not transmit the same kind of information.
Switches transmit Control Change messages, Note On, Note Off, Pogram Changes.
Potentiometers transmit Control Change messages, Pitch Bend, Polyphonic Aftertouch,
Monophonic Aftertouch.