Eowave Eobody1 - Manual (Page 15)

The status field indicates whether the signal on an analogue input
should be converted into a MIDI message or not. This field may be set
to ON or OFF. If the field is set to OFF, the input is said to be inactive
and no MIDI message relating to that input will be generated, even if
a signal does physically enter the device. If the field is switched back
to ON, the input is active and its associated MIDI message will be sent
each time the signal connected to that input varies in level.
Note: The smaller the number of active inputs is, the higher the acquisition frequency of the acti-
ve inputs will be.
Sets the resolution for sent data.
7 bits generates information from 0 to 127. This information format is
used by most common hardware & software MIDI devices.
10 bits generates information from 0 to 1023. This is a more accurate
format but can only be used to send pitch bend or CC data with
MSB/LSB (Most Significant Bits/Least Significant Bits). MSB/LSB can
only be used with softwares like Max/MSP, Jmax or PD.
Note about the high resolution:
• For the pitch bend message, the 10 bits of the sampled value are mapped on the ten most signifi-
cant bits of the MIDI message which actually counts 14 bits.
• For the control change message, the 3 Most Significant Bits (MSB) are sent via the Prm1 controller
number whilst the «normal» controller number exports the 7 Least Significant Bits (LSB). To obtain the
10 bit value, the following calculation must be computed: 10 bit value = (MSB controller value X 128)
+ LSB controller value. A Max/PD Abstraction is avalaible on the CD. See «Combine Ctr».
15
manual ©eowave/Ircam 2003
user’s manual • IV.5. - Use eo•body Editor
Status
on/off
Resolution
Status
Resolution
Zoom
Offset
Type
Channel
Gate
Sub sampling
Value 1
Parameter 1
Parameter 2
IV.5. eo•body input windows 1-8 & 9-16
With this window, you may set the inputs 1 to 8 from eo•body. Inputs 1 to 8 use a D-SUB
connector.
The whole IV.5. part applies to both input windows 1-8 and 9-16, substitute inputs 9-16
to 1-8 where necessary.