Cub Cadet MTD 90 Series - Manual (Page 99)

Exhaust
93
6. Remove the four screws that secure the outer heat
shield to the muffler. See Figure 8.6.
7. Slide the outer heat shield off of the muffler.
NOTE: The inner heat shield is serviced with the muffler.
8. Install the muffler by following the previous steps in
reverse order.
NOTE: Install a new gaskets between the muffler and the
manifold pipe also between the manifold pipe and
the cylinder head.
NOTE: Tighten the muffler and the manifold nuts to a
torque of 13 - 16 ft-lbs (18 - 22 Nm).
9. Test run the engine before returning to service.
Figure 8.6
Outer heat shield