Cub Cadet ogst3305 - Manual (Page 12)

To re move shave plate, re move slide
shoes as pre vi ously in structed, re move
the car
riage bolts, cupped wash ers
and hex nuts which at tach it to the
snowthrower hous ing. Re as sem ble new
shave plate, mak ing sure heads of the
car
riage bolts are to the in side of the
hous ing. Tighten se curely.
BELT RE MOVAL AND RE PLACE MENT
WARNING: Re move the spark
plug wire from the spark plug
and ground. Drain gas o line
from the fuel tank, or place a
piece of plas tic film un der neath
the gas cap to pre vent gas o line
from leak ing.
Auger Drive Belt
To re move and re place ei ther the au ger
drive belt or the drive belt, pro ceed with
the fol low ing in struc tions.
• Dis con nect chute crank as sem bly at the
dis charge chute by re mov ing the cot ter
pin and flat washer. See Fig ure 12.
• Re move the chute as sem bly by
removing the hex cap screws, chute
flange keep ers and hex locknuts. See
Fig ure 13.
• Re move the plas tic belt cover on the
front of the en gine by re mov ing three
self-tap ping screws and flat wash ers.
See Fig ure 14.
12
FIG URE 14
Self-Tapping Screw
Flat Washer
Belt
Cover
FIG URE 13
Chute Flange
Keeper
Hex Cap
Screw
Dis charge
Chute
As sem bly
Hex
Locknut
FIGURE 12
Plastic
Bushing
Flat Washer
Cotter Pin
Chute Crank
Bracket
Hex Nuts
Chute
Crank
FIGURE 11
Hex Shear
Bolt
Au ger
Shaft
Hex Centre Locknut
Shave Plate
FIG URE 15
Large
Shoul der
Bolt
En gine
Pul ley