Cub Cadet 190-295-100 - Manual (Page 8)

8
SECTION II. INSTALLATION AND REMOVAL OF MOWER DECK
A. INSTALLATION OF DECK
After locking the left lift link as described in Section I
(step B-2), start the tractor and use the hydraulic lift to
fully raise the left lift link (See Figure 5). Stop engine.
Figure 5
Remove the internal cotter pins, flat washers, and ad-
justment clevis pins to adjust the front caster wheel
arms to their highest setting (lowest deck setting) in the
height adjustment brackets of the deck (See Figure 6).
Figure 6
Adjust the rear deck rollers to their highest setting (low-
est deck setting) as follows:
1. From the left/rear of the deck, pull the adjustment
knob rearward to disengage the detent pin of the
knob from the hole in the detent hub (See Figure
7). Hold the knob rearward.
2. Turn the knob clockwise until the shoulder bolt
fastened to the roller pivot link is at the top of the
slot in the roller guide bracket (See Figure 7).
3. Release the knob and turn as necessary to align
the detent pin with the nearest hole in the hub.
Figure 7
Install the mower deck on the tractor as follows:
1. Place the tractor and mower deck on a firm and
level surface. Position the mower deck on the left
side of the tractor with the front of the deck toward
the front of the tractor (See Figure 8)
Figure 8
LEFT LIFT LINK
FULLY RAISED
CASTER
WHEEL
ARM
HGT. ADJ.
BRACKET
ADJUSTMENT
TOP
HOLE
INTERNAL
COTTER PIN
FLAT
WASHER
CLEVIS PIN
SHOULDER BOLT
PIVOT LINK
ADJUSTMENT
KNOB
DETENT
HUB
GUIDE
BRACKET
SLOT
ROTATE
DETENT PIN
SLIDE
UNDER