Ignition switch, Horn switch, 12v power outlet – Cub Cadet 414 User Manual
Page 8: Accessory power switch, Cargo box electric lift switch, Rear power outlet, Warning light cluster
8
•
To engage the parking brake, push brake pedal
down firmly, pull out on the parking brake latch, and
release foot from brake pedal. Brake pedal will stay
down and parking brake light on dash will come on
to indicate parking brake is engaged.
•
To release parking brake, push down on brake
pedal and parking brake latch will release.
Figure 3
Ignition Switch
WARNING:
Never leave a running machine
unattended. Always set parking brake, stop
engine and remove key to prevent unintended
starting.
The ignition switch is located on the right side of the
dash panel. To start the engine, insert the key into the
ignition switch and turn clockwise to the START
position. Release the key into the ON position once
engine has fired. See Figure 4.
NOTE: The shift controller will return the transmission to
neutral when the key is turned off. If the lever under the
cargo box is not in neutral it must be manually returned
to neutral to start engine. Refer to SECTION
8:Troubleshooting, page 20, Figure 22.
Figure 4
Refer to
Starting The Engine
in the Operation Section of
this manual for detailed starting instructions
The ignition switch is also used to operate the utility
vehicle’s headlights. Refer to
Operating The Headlights
on
page 11 of this manual for detailed instructions.
Horn Switch
(Optional)
The horn switch is located on the right side of the dash
panel. Push button to activate horn. See Figure 4.
12V Power Outlet
(Optional)
The 12V power outlet is located on the right side of the
dash panel. It is used for the convenience of plugging in
accessories that require a power source with a
maximum load of 5 amps at 12 volts. See Figure 4.
Accessory Power Switch
(Optional)
If equipped, the accessory power switch is located on
the right side of the dash panel. This switch turns power
on or off for optional accessories. See Figure 5.
Cargo Box Electric Lift Switch
(Optional)
If equipped, the cargo box electric lift switch is located
on the right side of the dash panel. It activates lift to
raise and lower cargo box. See Figure 5.
Rear Power Outlet
(Optional)
If equipped, the rear power outlet is located on the right
side of the dash panel. It turns power on and off for the
rear outlet. See Figure 5.
Figure 5
Warning Light Cluster
The warning light cluster is located in the middle of the
dash panel. There are two warning lights: battery light,
and parking brake light. The parking brake light indi-
cates when parking brake is engaged. The battery light
will indicate that the battery is not charging. See Figure
6.
Figure 6
Parking Brake
Latch
Horn Plug
Ignition
Switch
Stop
On/
Lights
On
Start
Cargo Box Electric
Lift Switch
(Optional)
Rear Power
Outlet
(Optional)
Accessory
Switch
(Optional)
Power
BATTERY
DIE CUT
PARKING
P
+
HOURS 1/10
DIE CUT
DIE CUT
Hour Meter
Battery
Light
Parking
Brake
Light