Cub Cadet J467 - Manual (Page 22)

22
5
WARNING
Servicing
Your
Utility
Vehicle
Figure 15
,UBE
"ALL
*OINTS
#6
"OOTS
3HOCK
Figure 13
Figure 14
Drive Belt
IMPORTANT: Several components must be removed in
order to change the vehicle’s drive belt. See your Cub
Cadet Dealer to have your drive belt replaced.
Inspecting Front and Rear
Shocks
1. Inspect the front and rear shocks every 100 hours or
once a year for oil leakage. See Figure 13. If exces-
sive oil leakage appears, have shocks repaired or
replaced by your local Cub Cadet dealer.
Inspecting CV Boots
1. Inspect CV boots (two on each CV joint axle end,
eight total) for tears every 50 hours. See Figure 13. If
tears or excessive wear appear, have boots replaced
by your local Cub Cadet dealer.
Inspecting Ball Joints
1. Inspect the upper and lower front A-arm ball joints on
each side of the vehicle and the two tie rod ends for
wear every 100 hours or once a year. See Figure 14.
If excessive wear appears, have ball joints or tie rod
ends replaced by your local Cub Cadet dealer.
Rear Knuckle Lubrication
1. Lubricate two grease fittings on each axle with 2 or
3 shots of grease every 50 hours or after each use if
consistently running unit in water deeper than axle.
See Figure 15.
Fingers or loose cloth-
ing can get caught in
rotating parts. Stop
engine and wait for all
moving parts to stop
before servicing.