Cub Cadet CC 500 EL - Manual (Page 20)

REPAIR PROCEDURES
16
To replace the switch box:
1. Unplug the power cord.
2. Slide the safety bail out of the switch box assem-
bly.
3. Remove the motor cover by following the steps
describe in the motor section of this chapter.
4. Unplug the wires from the rectifier. See Figure
3.7.
NOTE: Mark the wires or make a drawing to
ensure the wires are hooked up properly when
the switch box is installed.
5. Unhook the wiring harness from the motor
mount. See Figure 3.8.
6. Remove the two mounting screws using a T-27
Torx driver. See Figure 3.9.
7. Unhook the harness from the clips on the handle
bar.
8. Install the switch box assembly by following the
above steps in reverse order.
9. Test run the mower before returning to service.
Figure 3.7
Rectifier
Figure 3.8
Unhook harness
Figure 3.9
Mounting screws