COP-USA DVR2304SE-SL User Manual
Page 45
DVR User Manual
39
Advance settings are as follows:
Step 1: Enter into Menu
ÆSetupÆ P.T.Z ÆAdvanced tab. Refer to Fig 4-38:
Step 2: In the Advanced tab
, click preset “Setting” button to see a dialog box as Fig 4-39:
Fig 4-38 P.T.Z Configuration-Advanced Fig 4-39 Advanced-Preset
Step 3: In the preset setting tab, while clicking Setting button, a dialog
will pop-up as Fig 4-40:
z
User can control the dome by rotating up, down, left, right and
adjust the rotating speed zoom, focus and iris of the dome;
z
Select the serial number of the preset point. Click
button to
enable the PTZ wiper and click
button to enable the PTZ light. Fig 4-40 Preset Setting
Note: PTZ must support wiper and light, these two functional buttons can take effect. At the same time these two buttons are
just available when selecting PELCOP or PELCOD.
z
Click Save button to save the settings, click
icon to hide the
tool bar, right click to view the toolbar again; click
icon to exit the
current interface.
z
In the preset interface, click OK button to save the setting; click
Exit button to exit current interface.
Step4: In the Advanced tab
, while clicking cruise “Setting” button, a
dialog box will pop-up as Fig 4-41: Fig 4-41 Cruise Setting