Connection details, Protocols are shown as follows, Neon/ 9600bps – COP-USA AS75W User Manual
Page 7: Pelco- d/ 2400bps, Pelco- p/ 4800bps, Pelco- p/ 9600bps, Panasoni c/ 9600bps, Kalatel/ 4800bps, Ul t r ak/ 9600bps, Alec/ 9600bps
4
protocols are shown as follows:
NEON/ 9600Bps
ON
1 2 3 4
5 6
PELCO- D/ 2400Bps
ON
1 2 3 4
5 6
PELCO- P/ 4800Bps
ON
1 2 3 4
5 6
PELCO- P/ 9600Bps
ON
1 2 3 4
5 6
PANASONI C/ 9600Bps
ON
1 2 3 4
5 6
KALATEL/ 4800Bps
ON
1 2 3 4
5 6
Ul t r ak/ 9600Bps
ON
1 2 3 4
5 6
ALEC/ 9600Bps
ON
1 2 3 4
5 6
4
、
Setup of the Baud Rate of Communication. As shown in Figure 1, SW2 is
used to set the protocol of communication and the baud rate used by the dome camera.
DIP-6 and DIP-5 of SW2 are used to select the baud rate of communication and 4
different baud rates can be selected in maximum. If the controller adopts non-standard
baud rate, you can adjust it to be identical with that of the controller as per the
following table.
Baud Rate of Communication
Setup of Baud Rate
DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6
2400bps
OFF
OFF
4800bps
ON
OFF
9600bps
OFF
ON
19200bps
ON
ON
Table 3
Ⅳ.
CONNECTION DETAILS
Notice: Before carrying out any electrical installation ensure that the cable being used in at the
correct voltage and current rating for the application.