Compex FIT - Manual (Page 169)

169
EN
C
ompe
x F
it - U
ser M
anual
VIII EMC TABLES
The Compex Fit needs special EMC precautions and must be installed and
started according to the EMC information supplied in this manual.
All RF wireless transmission systems can affect the Compex Fit.
The use of accessories, sensors and cables other than those recommended
by the manufacturer may result in stronger emissions or reduce the
immunity of the Compex Fit.
The Compex Fit should not be used beside or stacked on top of any other
equipment. If you must use it side by side or on top of another system,
you should check that the Compex Fit works properly in the chosen
configuration.
Emissions test Compliance Electromagnetic environment - guide
CISPR 11
RF emissions
Group 1
The Compex Fit uses RF energy only for
its internal operation. Consequently, its RF
emissions are very low and are unlikely to
interfere with any adjacent electrical device.
CISPR 11
RF emissions
Class B
The Compex Fit is suitable for use in any
establishment, including a private dwelling
and a place connected directly to the
low voltage mains supply which powers
residential buildings.
Harmonic
emissions
IEC 61000-3-2
Not
applicable
Voltage
fluctuations/
emission
oscillations
IEC 61000-3-3
Not
applicable
RECOMMENDATIONS AND DECLARATION BY THE
MANUFACTURER CONCERNING ELECTROMAGNETIC
EMISSIONS
The Compex Fit is intended for use in the electromagnetic environment
specified below.
The customer or user of the Compex Fit should ensure that it is used in this
environment.