ChemoMetec NC-250 - Manual (Page 36)

8 Troubleshooting - Error messages
991-0251 Rev. 1.0 Feb-2013 20
Figure 13. Location, removal and inspection of the fuse
Disconnect the power supply from the NucleoCounter®. Then remove the fuse holder using
a screwdriver as indicated in Figure 13 (turn CCW). Inspect the fuse. If it needs
replacement use one as described by ChemoMetec A/S.
If the NucleoCounter® NC-250™ does not turn on after replacement of the fuse, or if the
fuse was not broken, please contact ChemoMetec A/S or the local distributor for further
instructions.