ChemoMetec NC-200 - Manual (Page 5)

991-0204 Rev. 1.1 September 2012 5
Quick Guide
1. Install the NucleoView® NC-200™ software and the NucleoCounter® NC-200™ instrument as
described in the documentation on the USB stick containing the NucleoView® NC-200™ software.
2. Start the NucleoView® NC-200™ software by double-clicking NucleoView® NC-200™ icon on the
desktop.
3. Wait while the NucleoCounter® NC-200™ instrument initializes (you will hear motors working).
When the LED on the instrument turns green the instrument is ready.
4. Click the button (below the F3 button) and select the protocol you want to use.
5. Click the button to see the application note for the selected protocol.
Check that you have all accessories needed for this protocol (cassettes, reagents ...).
6. Fill the cassette with the sample and place it in the cassette fixture.
7. Optional: Write a descriptive text in the Sample ID field and enter a user name in the Operator
field.
8. Press the Run button.
A few moments later the results of the analysis will be displayed.
9. Repeat steps 6 to 8 to perform more analyses of the same kind or repeat from step 4 to start a new
analysis.