Talkswitch 48 User Manual
Page 112
113
Appendices
Appendix C - Quick Commands and DTMF Functions
These DTMF Quick Commands can be dialed from a Local Extension or an outside
telephone at the Auto Attendant. To enter Command mode, dial
at a Local
Extension or at the Auto Attendant. If you are requested to enter a password, enter
the Administrator password. Next, enter any command followed by the
sign.
Command
Action
00
TalkSwitch tells you the Unit ID of the unit you are
connected to.
0x
Assign Unit ID 1 - 4 to TalkSwitch (x = 1 to 4)
30
TalkSwitch tells you which mode it is currently using
3x
Switch Modes (x = 1or 2)
4x
Record Auto Attendant (x = 1 to 9)
04x
Erase Auto Attendant messages (x = 1 to 9)
5x
Playback Auto Attendant messages (x = 1 to 9)
61 - 64
Record Auto Call Back Announced Messages 1 - 4
65
Record Prompted Call Back Announced Message
061 - 064
Erase Call Back Announced Messages 1 -4
065
Erase Prompted Call Back Announced Message
71 - 74
Playback Auto Call Back Announced Messages 1 - 4
75
Playback Prompted Call Back Announced Message
90
Set to Serial connection mode (default)
91
Set to USB connection mode
2xx 8
Enter Remote ext. (2xx) phone number
2xx 980 0
Enter Remote ext. (2xx) Turn off “Same Line Connect”
2xx 980 1
Enter Remote ext. (2xx) Turn on “Same Line Connect”
2xx 9
Enter Remote ext. (2xx) “Connect using:” Hunt Group
(Hunt Group = 9, 81-88)
1xx 61
Enable ‘Do not Disturb’ at the Local Extension
1xx 60
Disable ‘Do not Disturb’ at the Local Extension
Networked
Networked
TS-user manual 7th ED v3 Release.qxd 8/27/02 4:57 PM Page 113