BUCHI Fraction Collector C-660 - Manual (Page 23)

6 Operation
23 C-660 Operation Manual, Version F
Table 6-4: Parameter menu (cont.)
Parameter menu Description
Between peaks Fractionation time or volume, if the detector signal is below threshold.
Save as The entered parameters can be saved under P01 – P10.
Programs  Jumps into the Program menu.
Rack definition  Jumps into the Rack Definition menu.
Options  Jumps into the Options menu.
Table 6-5: Program menu
Program menu Description
 back Jumps back into the Parameter menu.
Load (empty, P01-P10) The previously saved programs P01 - P10 can be loaded.
Edit (new, P01-P10) New programs can be created and saved or existing programs changed.
View (empty, P01-P10) “Empty” is displayed when no programs have yet been saved. Otherwise, existing
programs can be selected and viewed. However, they can not be changed in this mode.
Delete (empty, P01-P10 “Empty” is displayed when no programs have yet been saved. Otherwise, the previously
defined programs P01 - P10 are deleted.
Table 6-6: Rack definition menu
Rack definition menu Description
 back Jumps back into the Parameter menu.
Rectangular rack  Jumps into Rack Menu 1 (Ractangular rack).
Irregular rack  Jumps into Rack Menu 2 (Irregular rack).
Table 6-7: Options menu
Options menu Description
 back Jumps back into the Parameter menu.
Language The appropriate operating language can be selected.
Contrast Contrast of the graphical display.
Table 6-8: Rack menu 1 (rectangular rack)
Rack menu 1 Description
 back Jumps back into the Rack definition menu.
Select rack You can select the predefined rack types FC4 – FC60 and Syncore Racks R4 – R96 or
your own racks under C01 - C10 and U11.
Tubes in X Number of tubes in X-direction.
Tubes in Y Number of tubes in Y-direction.
Pos. X 1 Position of the 1st tube in the X-direction (0.1 mm steps).
Pos. Y 1 Position of the 1st tube in the Y-direction (0.1 mm steps).
Pos. X xx Position of the last tube (xx) in the X-direction (0.1 mm steps).
Pos. Y xx Position of the last tube (xx) in the Y-direction (0.1 mm steps).
No. of racks The number of racks used is shown when the number of racks is >1: