BUCHI Glass Oven B-585 Kugelrohr - Manual (Page 12)

10
Glass Oven B-585
4 Putting into operation
Please inspect the package for any damage while un packing.
Any damage suspected of having occur red during transportation
should be reported imme diately to the appropriate authorities
(ditributor, post office, railroad or trucking company).
The original packaging should be saved in case it is required
at a later date.
4.1 Installation Location
The device must be set up on a clean, stable and level surface.
The device may not be used in rooms meant for use with ex-
plosive gases.
For safety reasons, there must be at least 30 cm between
the wall or other equipment and the rear and sides of the device.
No containers, chemicals or other devices should be placed
behind the device.
4.2 Power connections
Check to ensure that the voltage coming out of the electrical
socket agrees with the voltage stated on the devices ratings
plate. The glass oven must always be connected to an earthed
electrical socket. External couplings and extension cords must
have an earth wire (3-pole couplings, cords and sockets). It is
prohibited to cut or interrupt the earth wire. to avoid the risk of
damage to the device, or personal injury.
In a vertical operation care must be taken to ensure that every
cable of the B-585 not gets in contact with the heating element.
Discription of the interface:
Drive: interface for the drive unit
Vac Pump: interface for communications cable
B-585/V-500 to a vacuum pump V-500
Air Pump: interface for air pump Mettler for the KF-
Method (not availlabel at Büchi)
4.3 Installation of the glass parts and
the drive unit
For installation of the different parts please see chapter 5.6
"Converting the Glass Oven".
4 Putting into operation