Brookfield BF35 User Manual
Page 23
Brookfield Engineering Labs., Inc.
Page 23
Manual No. M13-10000
20. Gently slide the torsion spring through the aluminum clamp sleeve and into the
dial. Make sure the bottom of the torsion spring is seated properly inside the dial.
Tighten the set screw located at the top of the dial to secure the torsion spring.
21. Replace the stop block and the two screws. Make sure that the zero dial reading
is aligned with the fill on the stop block.
22.
Press down on the torsion spring until it is flush with the Aluminum Clamp
Sleeve and tighten the set screw.
23. Replace the bob and sleeve.
24. Re-attach the main housing cover and re-calibrate.
See also other documents in the category Brookfield Measuring instruments:
- CAP1000 Viscometer (37 pages)
- CAP2000 Viscometer (37 pages)
- CAP1000 Viscometer (30 pages)
- Dial Stepper Viscometer (35 pages)
- Dial Viscometer (35 pages)
- DV1 Viscometer (63 pages)
- DV2+Pro Viscometer (101 pages)
- DV2T Extra Viscometer (95 pages)
- DV2T Viscometer (95 pages)
- DV3T Rheometer (125 pages)
- DV-E Viscometer (37 pages)
- DV-I Prime (71 pages)
- DV-I Viscometer (49 pages)
- DV-II+ Digital Viscometer (51 pages)
- DV-II+ Programmable Viscometer (75 pages)
- DV-III Rheometer (64 pages)
- DV-III Rheometer (83 pages)
- DV-III Ultra Rheometer (133 pages)
- Falling Ball KF10 (18 pages)
- Falling Ball KF30 (19 pages)
- KU-1 Viscometer (11 pages)
- KU-1 Viscometer (13 pages)
- KU-2 Viscometer (19 pages)
- LFRA Texture Analyzer (46 pages)
- LFRA Texture Analyzer (30 pages)
- QTS25 Texture Analyzer (22 pages)
- R/S Coaxial Cylinder Rheometer (81 pages)
- R/S CPS Rheometer (62 pages)
- R/S-SST Rheometer (9 pages)
- RST Rheometer (69 pages)
- YR-1 Rheometer (64 pages)
- M14-TABTKIT (1 page)
- M14-TASBAWB1 (1 page)
- M14-TASBAWB3 (1 page)
- CT3 Texture Analyzer (56 pages)
- TA-DGA (2 pages)