Brookfield BF35 User Manual
Page 19
Brookfield Engineering Labs., Inc.
Page 19
Manual No. M13-10000
Section 8 - Disassembly
Disassembly
Clean the viscometer after every test.
1.
Remove the sleeve from the rotor.
2.
Remove the bob.
3.
Once the bob is removed, remove the splash guard and wipe down the bob shaft.
Clean all removed parts with soap and water and dry them thoroughly.
Keep the instrument upright at all times, especially when cleaning so that
water does not get into the bearings.
See also other documents in the category Brookfield Measuring instruments:
- CAP1000 Viscometer (37 pages)
- CAP2000 Viscometer (37 pages)
- CAP1000 Viscometer (30 pages)
- Dial Stepper Viscometer (35 pages)
- Dial Viscometer (35 pages)
- DV1 Viscometer (63 pages)
- DV2+Pro Viscometer (101 pages)
- DV2T Extra Viscometer (95 pages)
- DV2T Viscometer (95 pages)
- DV3T Rheometer (125 pages)
- DV-E Viscometer (37 pages)
- DV-I Prime (71 pages)
- DV-I Viscometer (49 pages)
- DV-II+ Digital Viscometer (51 pages)
- DV-II+ Programmable Viscometer (75 pages)
- DV-III Rheometer (64 pages)
- DV-III Rheometer (83 pages)
- DV-III Ultra Rheometer (133 pages)
- Falling Ball KF10 (18 pages)
- Falling Ball KF30 (19 pages)
- KU-1 Viscometer (11 pages)
- KU-1 Viscometer (13 pages)
- KU-2 Viscometer (19 pages)
- LFRA Texture Analyzer (46 pages)
- LFRA Texture Analyzer (30 pages)
- QTS25 Texture Analyzer (22 pages)
- R/S Coaxial Cylinder Rheometer (81 pages)
- R/S CPS Rheometer (62 pages)
- R/S-SST Rheometer (9 pages)
- RST Rheometer (69 pages)
- YR-1 Rheometer (64 pages)
- M14-TABTKIT (1 page)
- M14-TASBAWB1 (1 page)
- M14-TASBAWB3 (1 page)
- CT3 Texture Analyzer (56 pages)
- TA-DGA (2 pages)