AvaLAN Wireless AW900iTR - Manual (Page 10)

AW900iTR User’s Manual
PAGE 10 Technical Support (650) 384-0000 www.avalanwireless.com
8. On the Advanced Admin page, set the parameters as follows:
• Choose Device Type: Access Point or Subscriber Unit.
• For Subscriber Units, assign unique ID numbers in numeric order from 1 to 16.
• For an Access Point, enter the number of Subscriber Units that will be communicating with it.
• Choose an 8-digit hex (0-9 and A-F) Network Name that will be common among the AP and its
SUs and enter it. The hyphen is required.
• Choose a 32-digit hex encryption key and enter it. Again, the hyphens are required. This key
must match between the AP and the SU so make a note of it as well.
After entering the parameters, click the “Apply” button to save them to the radio.
9. When all of the radios are keyed and operating, connect them to your network and Ethernet de-
vices as desired and cycle the radio’s power to begin normal operation. Now, browser mamagement
of the SUs can be performed over the wireless network.
Note: Avoid plugging actively linked radios
into the same switch because this will corrupt the switch’s routing table and may cause network
problems just as if you had plugged a CAT5 cable directly between two ports of a switch (commonly
called a loop back).
Subscriber Screen Shot Access Point Screen Shot