Analogue Solutions Oberkorn sequencer - Manual (Page 9)

Oberkorn User Manual
Analogue Solutions | Output Type 9
With S-Trig it is swapped. So, say, 5v for off and 0v for on. (Though in practice S-trig is
implemented in a few different ways by different synth’s).
I have not tested Oberkorn with many S-Trig synth’s (since it was designed for the
‘standard’, more common positive gate synth’s and because S-trig synth’s are typically rarer
to find). But I have had reports back that it works fine with Korg MS synth’s, but inverted (as
you would expect). So to trigger the synth you must set a gate switch to off rather than on!