SoundCraft 1620LE - Manual (Page 8)

8
TYPICAL SPECIFICATIONS
INPUTS Six stereo inputs with individual balance and level Controls.
Phono 1 & 2 RIAA-equalized stereo phono, with two Part No. 1620-PC preamplifier cards supplied as
standard configuration.
Auxiliary 1-4 Switchable to any one of five line level sources or aPreamplified low level source.
Standard configuration: Aux 4 Input equipped with mono microphone preamplifier card, Part No. 1620-MC.
Optional configuration: Preamp source position accepts stereo phono preamplifier card, Part No. 1620-PC, or
mono microphone preamplifier card, Part No. 1620-MC; Phono inputs 1 & 2 alternately will accept mic preamp
card in place of standard phono preamp card.
Phono Inputs
Input Impedance 47k Ohms.
Gain 64 dB maximum @ 1 kHz (measured at House XLR).
Connector RCA-type phono jack.
Microphone Input
Input Impedance For 150 ohm microphone, electronically balanced.
Gain 60-84 dB, adjustable on card (measured at House XLR).
EIN < -126 dBu (22-22kHz).
Connector XLR-type three-pin female.
Auxiliary Inputs
Input Impedance 10k ohm nominal.
Gain 20 dB maximum
Connector RCA – type phono jack.
OUTPUTS
House Output:
i) Balanced
Transformer isolated, symmetrical, floating balanced
Output Impedance
< 50 Ohms.
Recommended Load >= 600 Ohms.
Frequency Response + 0/-1 dB, 20 Hz – 20 kHz.
THD +N < 0.1% 30 Hz – 20 kHz @ +20 dBu, 10k Ohms.
Maximum Output +25 dBu into 600 Ohms.
Connectors XLR-type three pin male.
ii) Unbalanced Single-ended, electronic
Output Impedance 75 Ohms.
Recommended Load >= 600 Ohms.
Frequency Response + 0/-1 dB, 20 Hz – 20 kHz.
THD +N < 0.05% 20 Hz – 20 kHz @ +20 dBu, 10k Ohms.
Maximum Output +20 dBu into 600 Ohms.
Connectors RCA-type phono jack.