SoundCraft 1620LE - Manual (Page 17)

17
LINE VOLTAGE SWITCH
Unless a tag on the line cord specifies otherwise, the Model 1620LE was shipped ready for operation with nominal 240 V AC power
mains. To change this for nominal 115 V AC operation, slide the VOLTAGE SELECTOR switch on the rear panel to the 120 position.
The voltage is visible in a window next to the switch slot. A small screwdriver should be used to move the recessed switch.
EXTERNAL CONNECTIONS
Note: See also the Block Diagram (page 22) for further details.
Input and output signal wires should be shielded cable, connected in accordance with standard wiring practice.
INPUT CONNECTIONS
Phono 1 & 2
The first two inputs of the Model 1620LE, as supplied from the factory, are equipped with phono preamplifier cards, Part No. 1620-PC.
Input is through standard RCA-type phono connectors. Most turntableshave a separate ground wire. A ground terminal for this
connection is located on the rear panel, adjacent to the input jacks for Phono 1 and 2.