Rightline Gear Jeep Trunk Storage Bag - Manual

1-Slide the hard plastic sheet into the top sleeve (Fig 1).
2-Velcro the (2) hard plastic shelves onto the horizontal
dividers (Fig 2).
3-Place items like gloves, tree trunk protectors, recovery
straps, snatch blocks, jumper cables, tool kits, air compres-
sors, bikini tops, jackets, clothing, and blankets in the (4)
storage compartments.
The Trunk Storage Bag straps to the rear vertical roll
bars, the rear seat headrests, and the attachment rings
on the bottom of the rear seat. Your Wrangler’s top can
be up or down. This product fits the Jeep Wrangler JK.
1-Position the bag behind the rear seat (Fig 5).
3-Buckle the A strap around the left rear vertical roll bar,
above the seat belt holder, without twisting the strap (Fig
5 and Fig 7).
Pack The Trunk Storage Bag
Attach The Trunk Storage Bag
Trunk Storage Bag Set Up Guide
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 1 Fig 2
5-Close the zippers and secure the Velcro closures at the
bottom of each compartment (Fig 4).
2-Buckle (2) of the rear side straps through their matching
attachment rings on the bottom of the rear seat (Fig 6).
Fig 6
4-Place smaller items in the inner mesh pouch (Fig 3).
Fig 5
Fig 7 Fig 8
2-door Jeep Wranglers
Fig 3 Fig 4
4-Buckle the D strap around the right rear vertical roll bar,
above the seat belt holder, without twisting the strap (Fig
5 and Fig 8).
5-Buckle the B strap around the left headrest, without
twisting the strap (Fig 5 and Fig 9).
6-Buckle the C strap around the right headrest, without
twisting the strap (Fig 5 and Fig 10).
Fig 9 Fig 10
7-Tighten all (4) straps. The top of the bag should follow
a straight line, parallel to the top of the rear seat (Fig
11).
A
B C
D
Attachment
Ring
Rear Side
Strap
Rear Side
Of Bag