Rightline Gear Edge Car Top Carriers - Manual

1-Place the Edge Car Top Carrier on the top of your ve-
hicle with its closed end facing forward.
2-Load your gear inside the carrier. Place items with
sharp or pointed edges in the middle and pack softer
items around them (Fig 1).
3-Close the zipper (Fig 2), fold the protective flap down,
and secure the Velcro closures.
The Edge Carrier comes with (4) straps. Attaching (2)
straps front to back between the cross bars or (2) straps
side to side between the side rails will sufficiently secure
the carrier. Using all (4) straps provides the most secure
method of attachment. Make sure your roof rack is an-
chored to your vehicle and don’t exceed its weight limit.
Pack The Carrier
Attach The Carrier - WITH A Roof Rack
Attach The Carrier - WITHOUT A Roof Rack
Edge Car Top Carrier Set Up Guide
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 1 Fig 2
(1) double-long strap will run through the front doors and
(1) double-long strap will run through the rear doors of
the vehicle.
WARNING: DAMAGE MAY OCCUR TO THE CARRIER
IF EXCESS MATERIAL FLAPS IN THE WIND.
TO ELIMINATE EXCESS MATERIAL, PACK THE
CARRIER FULL. IF UNABLE TO PACK FULL, FILL THE
FRONT CORNERS OF THE CARRIER, SMOOTH THE
TOP, AND PULL THE EXCESS MATERIAL DOWN OVER
THE SIDES. HOLD THE EXCESS MATERIAL SECURELY
IN PLACE WITH THE CARRIER’S STRAPS.
WARNING: DO NOT ATTACH STRAPS DIRECTLY TO
THE D-RINGS; DAMAGE MAY RESULT. THE D-RINGS
FUNCTION AS GUIDES FOR THE STRAPS, NOT AS
ATTACHMENT POINTS FOR THE STRAPS.
1-Unthread the short strap piece from the center buckle on
the first strap (Fig 3).
2-Attach the short strap piece to your rack by threading
its end through its loop and pulling tight (Fig 4). Secure the
long strap piece to the rack on the opposite side of the
vehicle by the same method.
3-Run both strap pieces through the d-rings and over the
top of the carrier (Fig 5). Make sure the center buckle is
facing up and the strap pieces are not twisted.
5-Repeat steps 1-4 for each strap used.
4-Thread the short strap piece back through the center
buckle and tighten (Fig 6).
Fig 4 Fig 3
Fig 6
Long Strap
Piece
Short Strap
Piece
Long Strap
Piece
Short Strap
Piece
D-Rings
Fig 5
METHOD #1: Through The Vehicle
1-Leave the first strap as originally provided. Unthread
the short strap piece from the center buckle on the second
strap (Fig 7).
3-Run the double-long strap through the vehicle, through
the d-rings, and over the top of the carrier (Fig 9). Make
sure the center buckle is facing up and the strap is not
twisted.
4-Thread the double-long strap’s end through its buckle
and tighten (Fig 10).
5-Repeat steps 1-4 for the second double-long strap.
2-Connect the second strap pieces’ loop-ends to the first
strap’s loop-ends to create a double-long strap (Fig 8).
Double Long Strap
Loop Ends
Buckle
Buckle
Tri-glides