Attachment (tools-on-board) assembly, Attachments, Attachment (toois-on-board) assembly – Panasonic QUICKDRAW MC-V5117 User Manual
Page 7: Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHMENT (Tools-on-Board) ASSEMBLY
A
CAUTION
Do not get the power cord caught under the agitator when using the vacuum
or attachments.
The attachments should be conveniently ¡jositioned on the side of the cleaner for easy access.
Assemble the hose and attachments to the cleaner as follows:
Place the hose on the tool holder in front of the handle. Grasp the end of the hose and push
it down over the wand, twisting as you push down.
Place the wand in the middle slot of the toot holder, twisting and pushing down over the short
hose to assure a good connection.
Store the dusting brush in the front of the tool holder.
Place the crevice tool into the rear slot of the tool holder.
Refer to the illustration in the Parts Identification section for correct attachment storage.
ATTACHMENTS
Dusting—►
Brush
I
----- Extension
J Wand
3Z)
Crevice
Toot
- 7 -