Changing the dust bag – Panasonic QUICKDRAW MC-V5117 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CHANGING THE DUST BAG

Always operate the vacuum with a genuine Panasonic Type U3 or U6 dust bag Installed.

Panasonic dust bags may be ordered through any authorized Panasonic dealer.

1. Pull outward on the

dust cover grip,

located on the top

front of the dust

cover and remove
the cover.

To remove the dust

bag, grasp the

cardboard portion
of dust bag and

pull it out.

3. Spread out the end of the

new dust bag.

NOTE: Pull carefully so
as not to tear the bag at
the folds.

Attach the new dust bag
onto the bag holder by

holding the bag collar

and pushing back as

illustrated.

5. The dust bag must be completely

installed Inside the dust
compartment for proper
operation.

The dust bag should not be

caught between
the lower
edge of the
dust cover and
the gasket as

indicated by the

arrow in the illustration.

6. Reinsert the tab provided on the end of

dust cover into the groove on the dust
compartment and press the cover into place.

NOTE: The dust
cover must be
completely and
correctly

Installed for
proper

operation.

- 1 2 -