Panasonic QUICKDRAW MC-V5117 - Manual (Page 16)

CLEANING EXTERIOR AND ATTACHMENTS
1 Unplug cord from wall outlet DO NOT drip water on cleaner
2 Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid
detergent and water, then wrung dry Wipe dry after cleaning
3 To reduce static electricity and dust build-up, wipe outer surface of cleaner and attachments
4 Wash attachments in warm soapy water, nnse and air dry Do not clean in dishwasher
or clothes washer
DO NOT USE ATTACHMENTS IF THEY ARE WET
A
CAUTION
Attachments used m dirty areas (such as under a re^igerator) should not be used
on other surfaces until they are washed They could leave marks.
REMOVING CLOGS
A
WARNING
Electric Shock or Personal Injury Haard
Disconnect electncal supply before servicing or cleaning the unit Failure to do so
could result in electncal shock or personal injury from cleaner suddenly starting
For best cleaning
results, keep the air­
flow passages clear
Unplug the power
cord from the outlet
before checking the
airflow passage
Check each starred
area occasionally for
clogs
Disconnect the wand from the short hose
and check the wand and hoses for clogging
Plug in the vacuum cleaner and turn it on
While running the vacuum cleaner with the
hose disconnected, stretch the hose in and
out to remove the clog
Pull down on
the suction
inlet cover
and check
for clogging
in this area
If the clog
still exists,
turn the
vacuum
OFF and
unplug the
power cord
Turn the
vacuum
cleaner over, exposing the underside Remove
the lower plate Remove the short nozzle hose
from the housing by lifting it straight up Inspect
the hose end and clear it of any obstructions
Reinstall the short nozzle hose and lower plate
See the Removing/lnstalling the Lower Plate
section for detailed instructions
- 16-