Panasonic CQDRX900U - Manual (Page 32)

Installation Guide
A
WARNING
This installation information is designed for experienced installers
and is not intended for non-technicaJ individuals. It does not contain
warnings or cautions of potential dangers involved in attempting to
install this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical system
and could result in serious personal injury or death.
□ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to the “WARN­
ING” statement above).
• Identify and label the car wires.
• Connect the car wires to the wires of the power
connector.
• Install the unit in the dash.
• Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution: This unit operates with a 12 volt DC nega­
tive ground auto battery system only. Do not attempt
to use it in any other system. Doing so could cause
serious damage.
□ Installation Hardware
No. Item Diagram Q’ty
® Mounting Collar 1
(2) Mounting Boll (5 mmo) 1
Power Connector 1
® Removable Face Plate Case 1
Trim Plate 1
Rear support strap 1
Tapping screw 1
Hex. Nut 1
Before you begin installation, look for the items on
the right which are packed with your unit. •
• Warranty Card....... Fill this out promptly.
• Panasonic Servicenter for Service Directory
...... Keep for future reference in case the product
needs servicing.
• Installation Hardware ........ Needed for in-dash
installation
32
CQ-DRX900U