Manual tightening function, S) reversing lever (forward/ switch lock/reverse), D) variable speed control trigger – Panasonic EY6181 User Manual
Page 7: I) speed selector switch, Bit holder, Battery pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Manual tightening function
1.
With the switch at off, the bit is locked In
place, and the tool can be used as a
manual screw-driver (up to 22.5 Nm, 230
kg-cm, 200 in, lbs.).
There will be a little play in the chuck, but
this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque than the
maximum torque of the driver (position
on the clutch), for confirming the
tightness of a screw or for loosening an
extremely tight screw.
(S) Reversing lever
(Forward/ Switch lock/Reverse)
CAUTION: Set the main switch at OFF and
wait until the bit has come to a complete stop
before operating this lever.
1.
For reverse rotation, set the lever to
reverse.
Check
the
direction
of
rotation
before
use.
2.
After use, set the lever at the center
(switch lock) position.
(D) Variable speed control trigger
1.
Depress the trigger slightly to start the
tool slowly.
2.
The speed increases with the amount of
depression
of
the
trigger
for
efficient
tightening
of
screws
and
drilling.
The
brake
operates
when
the
trigger
is
released
and
the
chuck
stops
immediately.
Note:
When the brake operates, a braking
sound may be heard.
This
sound indicates
engagement
of
the bit lock.
• Do not lock the tool (motor).
This may cause damage to the unit.
i) Speed selector switch
Choose a tow or high speed to suit the use.
ÉY6101/EY6100
EY6181
Torque
LOW
50 ' 350 min '(RPU)
50 ~ 350 min ■’ (RPM)
Strong
HIGH 100'1300 min '(RPM)
150- 1000min '(RPM)
Less
CAUTION: Check the speed selector switch
before use.
© Bit holder
Battery pack
ATTENTION:
The product that you have purchased
contains a rechargeable battery.
The battery is recyclable. At the
end
of
its
useful
life,
under
various
state and local laws, it may be illegal to
dispose
of
this
battery
into
the
municipal
waste
stream.
Check
with
your
local
solid
waste
officials
for
details
in
your
area
for
recycling
options or proper disposal.
1.
Press the battery pack release buttons
©
on
both
sides
and
puli
the
pack
away from the tool.
2. Charge the battery pack using the battery
charger.
3.
After the charging has been completed,
remove the battery pack from the charger
and connect it to the tool. Disconnect the
charger from the power source when not
in use.
Note:
EY9103,
EY9101
and
EY9182
can
not
be
recharged
with
the
l-hour
battery charger EV0001 and RE570.
Remove the battery pack to expose the bit
storage compartment inside the handle
I
housing.
A bit up to 50 mm, 1-31/32 long can be i
stored here.