Caution – Panasonic EY6181 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOR BATTERY CHARG
ER & BATTERY PACK
1) SAVE THESE IN
STRUCTIONS
This
manual
contains
important
safety
and
operating
instructions
lor
battery
chargers
EY0202, EY0001 and RE570.
2)
Before
using
battery
charger,
read
all
instructions
and
cautionary
markings
on
(1) battery charger, (2) battery pack.
3)
CAUTION
- To reduce the risk of
injury, charge only battery pack as shown
below.
c.
that
wire
size
is
large
enough
for
ampere rating of charger as specified
below.
RE570
EY970, EY9080, EY9086
Approx. 1 hour
EY0001
EY9001,EY9006
Approx. 1 hour
EY0202
EY9001,EY9080,EY9065
EY9006, EY9086
Approx, 15 min.
EY9101,EY9180,
EY9182
EY9103
Approx. 20 min.
Other
types
of
batteries
may
burst
causing personal injury and damage.
4) Do not expose charger to rain or snow.
5)
To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6)
Make sure cord is located so that it wilt
not
be
stepped
on,
tripped
over,
or
otherwise subjected to damage or stress.
7)
An extension cord should not be used
unless absolutely necessary.
Use
of
improper
extension
cord
could
result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. that pins on plug of extension cord are
the same number, size and shape as
those of plug on charger.
b.
that extension cord is properly wired
and in good electrical condition.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating,
Amperes
AWG Size of Cord
Equal to or
But less
Length of Cord. Feet
greater than
than
25 50 too 150
0
2
18 18 18 16
8)
Do not operate charger with damaged
cord or plug - replace them immediately.
9) Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
serviceman.
10) Do not disassemble charger; take it to a
qualified
serviceman
when
service
or
repair
is
required.
Incorrect
reassembly
may result in a risk of electric shock or
fire.
11)
To reduce the risk of electric shock,
unplug
charger
from
outlet
before
attempting any maintenance or cleaning.
12)
The
charger
and
battery
pack
are
specifically
designed
to
work
together.
Do
not
attempt
to
charge
any
other
cordless tool or battery pack with this
charger.
13)
Do not attempt to charge the battery
pack with any other charger.
14)
Do
not
attempt
to
disassemble
the
battery pack housing.
15) Do not store the tool and battery pack in
locations
where
the
temperature
may
reach or exceed 122T (50°C) (such as a
metal tool shed, or a car in the summer),
which can lead to deterioration of the
storage battery.