Additional safety rules – Panasonic EY6181 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
16)
Do not charge battery pack when the
temperature
is
BELOW
32“F
(0‘C)
or
ABOVE
104T
{40°C).
This
is
very
important.
17) Do not incinerate the battery pack. It can
explode in a fire.
18)
Avoid
dangerous
environment.
Do
not
use charger in damp or wet locations.
19)
The charger is designed to operate on
standard
household
electrical
power
only. Do not attempt to use it on any
other voltage!
20)
Do not abuse cord. Never carry charger
by cord or yank it to disconnect from
outlet. Keep cord away from heat, oil and
sharp edges.
21)
Charge
the
battery
pack
in
a
well
ventilated
place,
do
not
cover
the
charger and battery pack with a cloth,
etc., while charging.
22)
Use of an attachment not recommended
may result in a risk of fire, electric shock,
or injury to persons.
23)
Do not short the battery pack, A battery
short
can
cause
a
large
current
flow,
over heating and burns.
24)
NOTE:
If
the
supply
cord
of
this
appliance is damaged, it must only be
replaced by a repair shop appointed by
the
manufacturer,
because
special
purpose tools are required.
ADDITIONAL
SAFETY RULES
1)
Be aware that this tool is always in an
operating condition, since it does not have to
be plugged into an electrical outlet.
2)
When drilling or driving into walls, floors,
etc.,
“live"
electrical
wires
may
be
encountered. DO NOT TOUCH THE CHUCK
OR ANY FRONT METAL PARTS OF THE
TOOL!
Hold
the
tool
only
by
the
plastic
handle to prevent electric shock in case you
drill or drive into a “live” wire.
3)
If the bit becomes jammed, immediately
turn
the
main
switch
off
to
prevent
an
overload which can damage the battery pack
or
motor.
Use
reverse
motion
to
loosen
jammed bits.
4) Do not operate the reversing lever when
the main switch is on. The battery will
discharge rapidly and damage to the unit
may occur.
5)
During charging, the charger may become
slightly warm. This is normal. Do not charge
the battery for a long period.
6)
Use only a dry, soft cloth for wiping the
unit.
Do
not
use
a
damp
cloth,
thinner,
benzine,
or
other
volatile
solvents
for
cleaning.
7) When storing or carrying the toot, set the
reversing
lever
to
the
center
(switch
lock)
position.
8) Do not strain the tool by holding the speed
control trigger halfway (speed control mode)
so that the motor stops.
9)
Do not operate the speed selector switch
(LOW-HIGH)
while
pulling
on
the
speed
control
trigger.
This
can
cause
the
rechargeable
battery
to
wear
quickly
or
damage
the
internal
mechanism
of
the
motor.
• Changes or modifications not expressly
approved by MATSUSHITA ELECTRIC
WORKS, LTD. could void the user’s
authority to operate the equipment.