Panasonic CF-27 - Manual (Page 10)

Starting Up/Shutting Down
Starting Up
Power Switch
Open the display
^ Pull the carry handle forward.
@ Slide the latch toward the rear of the computer and hold it with one finger.
@ Lift up the latch with another finger
® Lift open the display.
Turn your computer on
Slide the power switch toward the rear of the computer and hold it for approjcimately
one second until the power indicator turns on before releasing it.
• The computer will not power on when the display is closed (except when con­
necting an external display).
• After confirming that the power indicator has turned on, avoid the following
until W^mdows has completed loading.
• Touching the power switch.
• Performing any keyboard or touch pad (or external mouse) operations,
• Closingihe display.
If die display is dosed while Windows is starting up, it is possible that color, etc.,
will not be displayed properly. Run the fMS-tKDS Prompt] ([Start] - [Programs]
- [MS-DOS Prompt]), and use full screen display mode by pressing CAlt ) +
CEm?0 ___ ________
After returning from the full screen mode C Alt ) + ( Enter ) again, the display
will be shown correctly.
• Once the computer is powered off. you must wait at least ten .seconds before
powering it on again.
• When the CPU temperature rises, the computer may not power on to prevent the
CPU from overheating. Should this happen, allow the computer to cool down
then switch the power on again.
if the computer still does not power on. please contact Panasonic Technical
Support.
If security indicator is displayed,
you must first enter your password. (G* "Security Measures")
Upon entering your
password and press­
ing ( Enter).
If the correct password is input. F=n
Will start
Over three incorrect attempts,
►
ns
WIN Not Start*
^{Power^o^
* If you are starting from the suspend mode (C5" "Suspend/Hiber-
nation Functions"), if after three attempts the correct password is not in­
put, or if no password is entered for about a minute, the computer returns
to the suspend mode.
When an application or file that was previously displayed ap­
pears on your screen,
the suspend or hibernation function has been set. (c^ "Suspend/Hibernation
Functions")