Panasonic TC-21SV10M EN - Manual (Page 25)

( VCR Operation )
G-Code Recording
You can schedule recording by inputting the G-Codes listed in
the TV programme columns in newspaper and magazines.
Always set to "Guide Channel" when reserving the G-Code.
1. Press the "G-CODE" button.
—
G-CODE
A
1____
Note;
Upon pressing the G-Code button after presetting 6
programme timers recordings, programme screen is
displayed.
2. Press the Direct Programme Number Selection button and
set the G-Code.
G-CODE
1 2 3 4 5 6 7 S 9
3. Press the "STORE" button.
f
G-CODE
1 2 3 4 5 6 7 8 9
P O S DATA START STOP
10 4 10:00 12:00
^1994 121 12 ;00j
Note;
- The Input Code will flash on and off if there is a read error
owing to an input miss.
- Press the Position Left or Right button during input to
change each number entry at your option.
- To clear an input code which has already been entered,
press the "N" button.
4. In case of other G-Code recording, Repeat steps 1 to 3 for
each programme,
5. Press the "MENU" button twice.
G-Code is a trademark applied for by Gemstar Development Corp.
G-Code system is manufactured under license from
Gemstar Development Corporation.
Playback of Indexed Programme
It is possible to index programme recorded on this unit, to make
locating specific programme start position faster. {The unit
searches for a pre-recorded index signal and the corresponding
programme is played back automatically). Insert a recorded
cassette tape with index signals.
1. By pressing the Index Search buttons to designate many
index signals backward of forward the unit should count off
before stopping.
— INOEX
/---------
►► FF -1
\_____
J
The diagram below shows a section of tape, with the VCR
stopped between two index signals.
Note from the diagram that nom designate the start of a
selected programme 2 programme back, the unit must count
three index signals so in such a case you would set "3" not "2"
Setting range : 1 -* 20.
►► FF -3
V____
When a index signal is detected, the numbers displayed will
be reduced.
When the specified index signal is detected, playback of the
corresponding programme starts automatically.
MENU
m m
p.TBACKING-1 f. INDEX
in ui Ca—ra
o-cooe STORE
czh-a
22