Panasonic NN-C980w - Manual (Page 23)

Before Requesting Service
ALL THESE THINGS ARE NORMAL:
The oven causes interference
. with my TV.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused
by small appliances such as mixers, vacuums, hair dryer, etc. It does
not indicate a problem with your oven.
The oven lights dim. When cooking with a power other than P10 - P3, the oven must cycle
to obtain the lower power levels. The oven light will dim and clicking
noises can be heard when the oven cycles.
Steam accumulates on the
oven door and warm air comes
from the oven vents.
During cooking, steam and warm air are given off from the food. Most
of the steam and warm air are removed from the oven by the air which
circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
1 accidentally ran my
microwave oven without any
food in it.
Running the oven empty for a short time will not damage the oven.
However, we do not recommend this to be done.
There are humming and
clicking noises from my oven
when 1 cook by Combination. These noises occur as the oven automatically switches from microwave
power to Convection, to create the Combination setting. This is
normal.
The oven has an odor and
generates smoke when using
the Bake, Combination and
flro/7 function.
It is essential that your oven is wiped out regularly particularly after
cooking. Any fat and grease that builds up on the roof and walls of the
oven will begin to smoke if not cleaned.
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in
securely.
Remove plug from outlet, wait 10
seconds and re-insert.
Circuit breaker or fuse is tripped
or blown.
Reset circuit breaker or replace
fuse.
There is a problem with the
outlet. Plug another appliance into the
outlet to check if the outlet is
working.
Oven will not start cooking.
The door is not closed
completely.
Close the oven door securely.
Sfarf pad was not pressed after Press Start pad.
programming.
-S
Another program has already
been entered into the oven.
Press Stop/Reset pad to cancel
the previous program and
program again.
The program has not been
entered correctly.
Program again according to the
Operating Instructions.
Stop/Reset pad has been
pressed accidentally.
Program oven again.
The words “DEMO MODE"
appear on the screen. Oven is set at Demo Mode. See pagelO (To use Function)
to turn off Demo Mode.
' When the oven is turning on, ^ ^ Roller Ring and oven bottom are Clean these parts according to ^
there is noise coming from dirty. Care of Your Oven (see next
Ceramic Tray.
_____________________
page).
* DEMO MODE is designed for retail store display.
Cooking and other functions will not operate during Demo Mode.
If it seems there is a problem with the oven, contact an authorized Service Centre.
23