Panasonic QUICKDRAW MC-V7367 - Manual (Page 21)

BEEORE REQUESTING SERVICË
^4*
A WARNING
Electrical Shock or Persons/ Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit Failure to do so
could result in electrical shock or personal Injury from cleaner suddenly starting.
Review this chart to find do-it-yourseif soiutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, shouid be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner wilt
not run. 1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
4. Tripped motor protector.
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
4. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
Poor Job of dirt
pickup.
1. Full or clogged dust bag.
2. Broken belt.
3. Carpet-bare floor setting incorrect.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
6. Worn brushes.
7. Hole in hose.
8. Dust cover improperly installed.
9. Belt not installed on motor shaft.
1. Change bag.
2. Replace belt.
3. Set in the correct position.
4. Clean hose or nozzle area.
5. Insert hose.
6. Replace brushes.
7. Replace hose.
8. Properly install dust cover.
9. Install belt on motor shaft.
Bare floor option
will not work.
1. Belt improperly installed with bare
floor selector in wrong position.
1. Properly install belt.
Dust escapes
the paper bag.
1. Bag improperly Installed.
2. Bag torn.
1. Properly install bag.
2. Replace bag.
Light will
not work.
1. Burned out light bulb. 1. Replace light bulb.
-21
-