Panasonic PANASYNC SL90I TX-D9S55 - Manual (Page 8)

Installation
Connecting Procedures
Turn off your computer.
Connect the signal and power connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS / 2 or compatible models
CEE22
(T) Connect the supplied 15 pin mini D-Sub cable to the monitor’s Port A.
Then connect the other end of the supplied 15 pin mini D-Sub cable to the computer's corresponding
15 pin mini D-Sub video connector.
(D First connect the supplied AC power cord to the CEE22 connector on the rear of the monitor.
Then connect the other end of the AC power cord to a grounded power outlet.
B. Apple computer
(T) Connect the supplied 15 pin mini D-Sub cable to the
monitor's Port A.
Then connect the other end of the supplied 15 pin mini
D-Sub cable to a UNIMAC-82D MAC adapter and the other
end of the MAC adapter the computers to the computer’s
corresponding 15 pin mini D-Sub video connector,
d) First connect the supplied AC power cord to the CEE22
connector on the rear of the monitor. Then connect the
other end of the AC power cord to a grounded power
outlet.
Panasonic MAC adapter
If your need an adapter and one is not provided by your dealer, call 1-800 PANASYS (1-800-726-2797).
— Caution:
To prevent the cable from coming loose, the cable connectors must be securely fastened with screws.
C. BNC connector signal computer
Blue video signal
Green video signal
or sync on green
Horizontal sync signal or
composite sync signal
Red video signal
(D Connect the BNC signal cable (Not supplied) BNC connectors to the monitor’s Port B.
Then connect the other end of the BNC cable, usually a 15 pin mini D-Sub connector, to the computer’s
corresponding 15 pin mini D-Sub video connector.
(D First connect the supplied AC power cord to the CEE22 connector on the rear of the monitor.
Then connect the other end of the AC power cord to a grounded power outlet,
4 Connection of AC Power Supply
If the AC power supply voltage is in the range 100 to 240 V, either 50 Hz or 60 Hz frequency can be used.
There is no AC 100 V / 240 V selector switch as selection is automatic. * •
Precaution:
• In order to use the display unit safely, use a power cord that Is properly grounded.
• AC plug cords for the following countries must be used as follows:
U.S.A................ UL Canada............. CSA
For use in other countries, make sure that the AC cord meets the safety standards of each country.