Panasonic SD-BT10P - Manual (Page 17)

When the Start pad is pressed:
Display Reason How to reset
BASIC
WHOLS
WHEAT
BAKE
LIGHT
RAPID
DOUGH
Indicating light flashes.
Beeper sounds.
The oven area is hot (above 40®C).
This may occur during repetitive
use. You must allow the unit to cool
down before reusing.
When the unit has cooled to below
40°C, “TEMP” will disappear from
the display window and the red
indicaing light will go out.
To use again, press SELECT and
START pad.
During a power failure:
Display Reason How to reset
BASIC
WHOLE
WHEAT
ni-r'iri
BAKE
LIGHT
U ' U U RAPID
DOUGH
There has been an interruption in
the power supply {power failure,
unplugging of the power cord, or a
malfunctioning of household fuse or
breaker).
This display appears
and operation stops.
If the outage lasts longer than 10
seconds, the operation of the unit stops.
Remove the dough and start again
using all new ingredients.
If the interruption in the power
supply is momentary, the operation
will not be affected.
^ - - -- -
About the motor protection device
If the unit is overloaded and an excessive force is applied to the motor, the protection device will
stop the motor. After approximately 30 minutes, the motor will automatically start running again. It is
recommended to restart with fresh ingredients.
If the kneading blade is restricted by hard dough, take out the dough. The
unit will restart 30 minutes later.
Check to see if the kneader mounting shaft of the bread pan can rotate.
If it can rotate, restart the bread maker after 30 minutes. If it cannot rotate,
service will be required.
— 16 —