Panasonic WVBP110 - Manual (Page 9)

Caution:
To prevent fire or shock hazard, the UL listed
wire VW-1, style 1007 should be used for the
cable for AC 24V Input Terminal.
Table 1
Video Cable
1. It is recommended to use a video monitor whose
resolution is at least equal to the camera's.
2. Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
• It is recommended to use 75-ohm coaxial cable.
• Always set the last monitor's termination switch to
75 ohms, and set the ternrination switches of inter­
mediate monitors to high impedance (Hi-Z) posi­
tion.
Monilor Monitor
Type of
coaxial cable RG-59/U
(3C-2V)
RG-6U
(5C-2V)
RG-11/U
(7C-2V)
RG-15/U
(10C-2V)
Recommended
maximum
cable length
(ft) 825 1,650 1,980 2,640
(m) 250 500 600 800
Wiring precautions:
• Do not bend coaxial cable into a curve whose
radius is smaller than 10 times the cables diame­
ter.
• Never staple the cab(e-not even with circular sta­
ples. Mismatching will occur.
• Never crush or pinch the cable.
All of these will change the impedance of the
cable and cause poor picture quality.
The maximum extensible coaxial cable length
between the camera and the monitor is shown in
the table 1. Since cable quality varies among man­
ufactures, verify video quality before final installa­
tion if maximum lengths are to be used.
-
7
-