Infra-red remote controller and digital scanner, How to operate the digital scanner – Panasonic NV-G45 Series User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INFRA-RED REMOTE CONTROLLER AND
DIGITAL SCANNER
Part Number: VEQ0685
O VTR On/Off Button
^ Memory/Search Lock Button
© Reset Button
^ Programme Position (Channel) Selector Buttons
select channel
press button
1-9 Q—CD respective channel
10
s-CD-ra
20
11-32
for example 32
If more than 5 seconds pass between the first, second and
third push, the channel will not be changed normally.
0 Record Buttons (•)
0 Pause/Still Button (II)
0 Rewind ^^/Review @ Button
0
Slow Buttons
0 Reverse Play Button
Double Speed Playback Button (x2)
^ > / C u e
@ Button
Play Button (^)
0 Still Advance Button (!!►)
Time Search Button
(T)
Transmit Button
Bar Code Reading Section
@ Digital Scanner On/Off Switch
@ Bar Code Reader Display
0 Date Display
© Start Time Display
e
End Time Display
O Channel Display
0
Check Indicator
@ Transmitting Section
How to operate the Digital Scanner
Set the Digital Scanner On/Off Switch to “ON”.
• If no operation is performed for more than 25 seconds, the
scanner wiil automaticaliy switch over to the power-saving
standby condition and the iamp wili go off. (in this case, if
bar codes have already been read but not yet transmitted
to the VTR, the data will be cancelled.)
•When the Digital Scanner On/Off Switch is set to “ON”
but the lamp is not lit, set the switch to “OFF” and then to
“ON” again.