Panasonic KX-TS401W - Manual (Page 25)

Line Indicator Programming
All of the line indicators are preset to ON. If there is (are) a line(s) not
connected, the line’s indicator wiil remain red. To turn off the indicator,
program as follows.
1. Press I program ! to start programming.
2. Press fHOLDl. then press ©•
• “COL” is displayed.
3. Press O, (2], d] or ( 4 ) to select the line indicator.
1: Line 1 (“LI”)
2: Line 2 (“L2”)
3: Line 3 (“L3”)
4: Line4(“L4")
• Current setting “ON” (or “OFF”) is dispiayed.
4. Press ® (OFF) to deactivate the indicator.
• To activate the line indicator again, press Q] (ON).
Incoming Call Tone Programming
When you are using one line, you can know if another cali arrives on the
other line by hearing a series of two tones every 15 seconds. This incoming
caii tone can be set/eliminated by programming. Factory preset is OFF.
1. Press I PROGRAM] to start programming.
2. Press (HOLD], then press
3. Press (T] or (
2
).
1: Incoming call tone will sound as long as the other line rings. (ON)
2: Incoming call tone will not sound. (OFF)
• When the RINGER selector(s) is set to OFF, the incoming call tone will
not sound.
25