Panasonic mc-v9620 - Manual (Page 7)

USE - HOW TO START
WARNING
Personal Injury and Product Damage Hazard
• DO NOT plug in if switch is in ON position. Personal injury or damage could result.
• The cord moves rapidly when rewinding. Keep children away and provide a clear
path when rewinding the cord to prevent personal injury.
• DO NOT use outlets above counters. Damage to items in surrounding area could occur.
NOTE: To reduce the risk of electric shock, this vacuum cleaner has a polarized plug, (one blade is wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified eiectrician to instali the proper outlet.
DO NOT CHANGE THE PLUG IN ANY WAY.
TO REWIND: Remove the cord from the cord grip.
Unplug the cleaner. Hold the plug white rewinding
to prevent damage or injury from the moving cord.
Push cord rewind button. The cord will not rewind
until the cord rewind button is pushed.
2. Snap
cord into
grip to
prevent
accidental
rewinding.
3. Plug cord into 120-volt outlet located near the
floor.
4. Lower wand
from upright
position by
pressing on the
handle release
pedal.
5. Select a pile
height setting by
pressing the small
pedal on the rear.
The pile height
setting is shown in
the window.
SUGGESTED PILE HEIGHT SETTINGS
For best deep down cleaning, use the XLO setting. However, you may need to raise the height to make
some jobs easier, (such as scatter rugs and some deep pile carpets) and to prevent the vacuum cleaner
from shutting off. Suggested settings are: XLO- most carpets and bare floors. LO-low to medium pile.
MED-medium to deep pile. Hl-shag; deep pile; scatter mgs.
HANDLE SWITCH
2. There are two
positions on the handle.
Bare Floor/Off and
Carpet. Bare Floor/Off
position turns the
power bmsh off on the
Power Nozzle to be
used on uncarpeted floors. The Canister motor
only will run. Carpet position turns on both the
Canister motor and the Power Nozzle motor for
normal carpet cleaning.
-5-