Panasonic mc-v9620 - Manual (Page 10)

BAG CHANGING
For best cleaning results, the dust bag should
be changed often. Use Panasonic micron dust
bag type C-5
3. Remove cardboard
tab from red bag mount
by pressing away and
lifting up.
4. Pull bag out of the
red bag mount.
A
1, Unplug cord from
wall outlet.
2. Pull lid release
out and up, then lift
canister hood.
5. The red bag
mount will flip
forward after
removing bag. This
will prevent the lid
from closing until a
new bag Is Installed.
6. Raise red bag mount up.
7. Install bag into slots
pushing down until
the cardboard tab
locks into position and
the holes align.
8. Close and latch
canister hood.
9. Plug cord into wall outlet.
10. Bags are available at Panasonic Dealers and
Distributors.
CAUTION
NEVER REUSE A DUST BAG. Very fine materials, such as carpet fresheners, face
powder, fine dust, plaster, soot, new carpet lint, etc. can clog the bag and cause it
to burst before it is full. Change bag more often when vacuuming these materials.
MOTOR SAFETY FILTER CLEANING
Check motor safety filter occasionally and clean when dirty.
A
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the motor safety filter. Be sure the filter is dry
and properly installed to prevent motor failure and/or electrical shock.
1. Unplug cord from
wall outlet and
remove bag.
2. Pull out safety
filter as shown.
3. Wash filter in
warm soapy water,
rinse, then air dry.
Do not clean in
dishwasher or
install while damp.
4. Snap filter back
into canister.
5. Install bag.
-8-