Panasonic CT-27S20 - Manual (Page 33)

Code From Index Sheet
Programming the Illuminated Remote Control Using Access Codes
The remote control can be preset for othermanufacturers, by utilizing the MODE SELECTION BUTTONS Гог CABLE,
DSS, VCR, RCVR (a Receiver or Amplifier), CD, LD, and AUX (Гог Cassette Players or a DVD )
Procedure - Code Kriown
Procedure for setting up the remote using the
numerical buttons.
Determine brand of device
Identify code(s) associated with the brand in the
infrared code index (located in this manual on
pages 34 Ihru 37) Record all possible codes
Confirm the device is plugged in and operating
properly
m Press and hold the button, then the (^§)
button so that both are pressed at the same
time for^at.leasl S seconds] All of the Mode
buttons will flash.
Press the desired Mode button That Mode
button will illuminate steadily. All other buttons
will go out.
Enter the 3-digit code, by using the numeric
keypad (0 through 9 buttons).
1Г you entered a valid code, the mode key will blink
twice then go out
Now your remote Is set for this code. ^
Ì4l Press
^ A ^
% ^
iriE ( ae TI d
? to test your device,
NOTE: Some brands have multiple codes. Repeat
the procedure using each listed code until
the device responds correctly.
□ If you enter an unlisted code, or if you do not
complete your entry within 30 seconds, the mode
key illumination will go out and the settings will not
change
Infrared Remote Codes for Specific Components
Heipful Hint: Write down the code numbers for your components In the apace provided below. This
will serve as a handy reference whenever you need to reprogram your remote control.
CABLE
Cable TV Canverter Впн
□ □
VCR
Video Cassette Recorder
□П
CD
Compact Disc Player
П
DSS
Digital SalellilB System
RCVR
Receiver or Amplifier
LD
Laser D isc Player
___ 1
□ □ □
□thsf Скхлрапвп! OlhBT Солрапвл! other Can^vwnl
1
Dlhef DompoOanL
II
Olher Conpanenl
II
Dlher CoMiponenL
[
- 3 3 -