Yamaha YSP-1100 - Manual (Page 29)

GETTING STARTED
Using the remote control Turning on the power
This section describes how to control this unit using the
supplied remote control. The functions of the remote
control change depending on the position of the operation
mode selector. Set the operation mode selector to YSP to
switch to the operation mode of this unit. The buttons on
the remote control numbered © to 0 are operational only
when you select YSP. Also, functions of the buttons
numbered ® to ® vary depending on the position of the
operation mode selector. The corresponding functions of
the buttons, see page 9.
You can control other components by setting the appropriate
remote control codes (see page 81). Once the remote control code
for each input source (DVD, VCR, STB, TV or AUX) is set, see
“Controlling other components” on page 82 for further
information on the specific functions of the available remote
control buttons for each input source.
Operational buttons only when YSP is
selected
Press STANDBY/ON on the front panel or on
the remote control to turn on the power of
this unit.
The volume level appears in the front panel display
and then the input source and beam mode currently
selected are displayed.
ch/J
Front panel Remote control
2 Press STANDBY/ON on the front panel or on
the remote control again to set this unit to
the standby mode.
Nate
When the unit is in the standby mode, only STANDBY/ON on the
front panel or on the remote control is operational, and the other
control buttons on the front panel or on the remote control are not
operational until the power of this unit is turned on.
25
En