Yamaha YSP-1100 - Manual (Page 13)

CONTROLS AND FUNCTIONS
Remote control
The functions of some buttons change depending on the
position of the operation mode selector ((g)). This section
basically describes the functions of the remote control
used to control this unit.
You can also control other components using the remote control
once you set the appropriate remote control codes. See
“Controlling other components” on page 82 for details.
(i>
0 Infrared window
Outputs infrared control signals. Aim this window at the
component you want to operate.
( 2 ) STANDBY/ON
Sets this system to the standby mode (see page 25).
(3) Transmission indicator
Lights up when infrared control signals are being output.
0 Input selector buttons
Use to select an input source (STB, VCR, DVD, AUX or TV).
Use to change the control area of the remote control. ((g):TV/AV)
® VOL MODE
Turns on or off the volume modes (see page 55).
® AUTO SETUP
Use to enter the AUTO SETUP menu (see page 29).
® Numeric buttons
Use to enter numbers. ((g):TV/AV)
® STEREO
Use the playback sources in 2-channel stereo (see
page 47).
® Sound field program buttons
Use to select sound field programs (see page 50).
® CH LEVEL
Adjusts the volume level of each channel (see page 73).
® Cursor buttons ^ / Yz / <] / |>, ENTER
Use to select and adjust SET MENU items.
Use to select DVD menu items. ((g):TV/AV)
© TEST
Outputs a test tone when adjusting the output level of each
speaker (see page 72).
® VOLUME+/-
Increases or decreases the volume level of this unit (see
page 41).
® MUTE
Mutes the sound. Press again to restore the audio output to
the previous volume level (see page 41).
© TV INPUT
Switches the input source or the TV (see page 82).
® DVD playerA^CR control buttons
Use to control the DVD player or the VCR (see pages 82
and 83).
© My beam microphone
Use to collect the test tones from this unit when using the
my beam auto-adjust function (see page 48).
9
En