Instructions for connection of speaker cables – Yamaha PC4002M User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTRUCTIONS FOR CONNECTION OF SPEAKER CABLES
1. Make sure the power to the amplifier is OFF
2. Unscrew the covers over the speaker terminals
(Terminal covers are not installed in USA model)
Screw
3. For each cable, strip the insulation off one end of the speaker cable for about 10mm and twist and tin the wires. Pass the
tinned wires through the terminal hole and tighten the screw to grip the cable in place.
4. Replace the covers over the speaker terminals. Make sure that the speaker cables are fed down through the gap at the bottom
of the cover, and are not pinched or trapped by the covers.
5. If all other components are connected, turn on the amplifier.
expozed to touch the chassis or cover.