Panasonic KXL-D740 - Manual (Page 31)

Details of Setup Disk Software
About the installation copy
Setup disk contains the following programs (O, ® and ® ). When installing the
software, programs @ and © are copied entirely. However, in case of program
O, only
one file ( © ,® o r © ) is copied, depending on your hardware condition ( table below).
Installation will automatically choose ® or ©.
O ASPI Manager
File Condition
© ASPIFMGR.SYS
when your computer has both Card Service and
Socket Service.
® ASPIFDBK.SYS when your computer has only Databook CardTalk.
© ASPIF365.SYS
when your computer has neither Card Service nor
Socket Service.
© CD-ROM Device Driver
KMECD.SYS
© Microsoft MS-DOS CD-ROM Extensions
MSCDEX.EXE
rOptions for AS^Manager (for sophisticated users) |
Each file of ASPI Manager has the following options.
© ASPIFMGR.SYS
/port=XXX
Since the I/O port is needed for the PC card, add this line and specify
the base address at XXX using a hexadecimal number. The PC card
occupies 16 bytes of space starting the specified base address. If
you don’t specify the I/O base address, 240h is applied. If the
specified address is already used, you may specify another base
address from the following addresses. Also, depending on the
computer, the I/O port may need to be specified in the Card
Manager. Refer to your computer manual.
140 180 220 230 240 250 260 270 280 290 300 320
/socket=X
When you are using a personal computer with more than two
PCMCIA card slots, add this line and specify the slot at X, where
you are inserting the PC card. If you specify 0 or you don’t specify
the slot, the installation program searches all slots, and uses the
first available slot.
/BOFF
Setting this option turns off the beep sound that is generated when
inserting or removing the PC card.
O
c
CT
(D
0)
o
a
3
(O
D
a
u
m
o
c/>
a
c
■O
№
5T
0)
Q
(Example) DEVICE=C:\CDRM\ASPIFMGR.SYS /port=280 /socket=2
31